Zenoah G6200 Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Elektrické řetězové pily Zenoah G6200. Zenoah G6200 Owner`s manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 16
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
G6200
G
B
GB-1
G6200
OWNER’S MANUAL
CHAIN SAW
G
B
115 32 02-10 (001)
Original Language
Zobrazit stránku 0
1 2 3 4 5 6 ... 15 16

Shrnutí obsahu

Strany 1 - Original Language

G6200GBGB-1G6200OWNER’S MANUALCHAIN SAWGB115 32 02-10 (001)Original Language

Strany 2 - WARNING!!!

G6200GB-10 ICING PREVENTION SYSTEMThis system prevents icing of the carburetor which some-times happen while sawing in winter.When your saw has stop

Strany 3 - Contents

G6200GBGB-116. Sawing• Before proceeding to your job,read the section “For Safe Op-eration”. It is recommended tofirst practice sawing easy logs.This

Strany 4 - 1. For safe operation

G6200GB-12A log lying on the groundSaw down halfway, then roll the log over and cut fromthe opposite side.A log hanging off the groundIn area A, saw u

Strany 5

G6200GBGB-13 PERIODICAL SERVICE POINTS1. Cylinder finsDust clogging between the cylinder fins will cause overheat-ing of the engine. Periodically che

Strany 6

G6200GB-14 WARNING• This saw is equipped with one of the following lowkickback bar/chain combinations:Zenoah Part NumberBar Size Guide Bar Saw Chain

Strany 7

G6200GBGB-159. Troubleshooting GuideCase 1. Starting failure WARNING• Make sure the icing prevention system is not working.11. SpecificationsPower u

Strany 8 - 4. Fuel and Chain Oil

G6200GB-16Limited warrantyShould any failure occur on the product under normaloperating conditions within the applicable warranty pe-riod, the failed

Strany 9 - 5. Operating the Engine

G6200GB-2EXPLANATION OF SYMBOLS AND SAFETY WARNINGSRead operator's instructionbook before operating thismachine.Wear head, eye and earprotection.

Strany 10

G6200GBGB-3Contents1. For Safe Operation ... 42. Explanation of Symbols on the Machine

Strany 11 - 6. Sawing

G6200GB-41. For safe operation WARNINGThis chainsaw has been especially designed for treemaintenance and should therefore only be used bytrained opera

Strany 12 - 7. Maintenance

G6200GBGB-520. Operate the chain saw only in wellventilated areas. Never start or runthe engine inside a closed room orbuilding and potentially explos

Strany 13 - 0.6 ~ 0.7 mm

G6200GB-62. Explanation of Symbols on the Machine WARNING• For safe operation and maintenance, symbols are carved in relief on the machine.According

Strany 14

G6200GBGB-75. Fit the chain cover to the power unit and fasten thenuts to finger tightness.6. While holding up the tip of the bar, adjust the chainten

Strany 15 - 10. Disposal

G6200GB-84. Fuel and Chain Oil FUEL WARNING• Gasoline is very flammable. Avoid smoking orbringing any flame or sparks near fuel. Make sureto stop t

Strany 16 - Limited warranty

G6200GBGB-97. Allow the engine to warm up with the throttle leverpulled slightly. WARNING•Keep clear of the saw chain as it will start rotatingupon s

Komentáře k této Příručce

Žádné komentáře